Comment

Comment by BassSquatch! on March 13, 2011 at 12:36pm

Hey guys I'm new here. Here is a TandemBlade Inline spinner.

[IMG]http://i831.photobucket.com/albums/zz236/fotocorn/Mobile%20Uploads/...[/IMG]

Comment by Todd Cazavelan on April 23, 2010 at 8:48pm

That's Cool Al, I'm glad to hear it worked out.

Comment by Al Osmond on April 23, 2010 at 7:43am

And it passed the field test with an A+!

Comment by Al Osmond on April 15, 2010 at 7:51am

I put a lip on the pike lure and it passed the bathtub test. I'll be able to do some field runs now that fishing season has started.

Comment by Al Osmond on April 10, 2010 at 6:26pm

Thanks for the info guys.

It sits upright in the water, but the eye screw on the lure as it is pictured here is too high on the body. It just gets pulled along at a skew. I put it at the front of the snout but it now has no action.

I have some .22 calibre pellets that I use for weight, but I was hoping that a lathed body would alleviate the need for them. I'll have to play with them a bit I guess.

As for plastic lips, does anyone have any suggestions or tricks to make and install them? I'm still gathering up tools for luremaking and I have difficulty getting them symmetrical and positioned good.

Take care for now, guys. Catch ya later on.

Al.

Comment by Todd Cazavelan on April 9, 2010 at 9:15pm

Hey Al, I like the paint job on the pike lure, I read what bill wrote and I have seen the same things done by the Linder Bros. I did see one other approach to weighting a lure, they made a grove in the bottom and pured lead down the belly. Todd

Comment by Bill.Strickland on April 9, 2010 at 8:32pm

Hello Al. How does the pike lure sit in the water? What I like to do is add weight to the belly of the lure. I usually do this in the beginning stages. I seal the lure first, add the eye screws and hooks, and see how it floats. To fine tune the lure I drill a hole in the bottom where I want to add the weight. Split shot of various sizes works great. Epoxy them in, let dry and test again. When you have the desired effect or float, fill in any gaps and finish the lure. I suggest putting a plastic lip on the front of the pike, to help pull it down into the water. This will also give it a wiggle.

Comment by Al Osmond on April 9, 2010 at 6:41pm

Me too. It rides a bit low in the water but it turned out real well.

The pike lure was just a prototype that needs to be experimented with. It failed the bathtub test and when I tried it in a salmon tank at work (the hooks were taped over haha) it failed miserably. I'm might try putting a lip on it and seeing if it will make a good diver. Do you have any suggestions as to what I can do to it? Anything that will keep it upright and give it a bit of action.

Comment by Jason Vaughn on April 8, 2010 at 9:55pm

Pretty cool. I dig the popper

Comment by Al Osmond on April 8, 2010 at 7:25pm

Hey Bill,

In answer to your question about a finish, here's a video on youtube where a guy does it with epoxy. Enjoy.

http://www.youtube.com/watch?v=l2ifwOwxldo

Al

• ‹ Previous
• 1
• 2
• 3
• …
• 7
• Next ›
• Page